Interior:
Removing the side panel was very easy, by just removing two thumbscrews off the back. Once the panel is off, you can see the entire interior of the case. The first thing that caught my eye was the vertical bracket that holds a 120mm fan; this is the "Core Fan" system. I'll discuss this bracket in a minute after I check out the rest of the case.
At the front bottom of the case, you have a hard drive cage that has been rotated so the front 120mm intake fan will blow cool air across the entire drive. I like this orientation of the drives; it allows you easy access to your hard drives if you tend to change them often. The hard drive cage is removable so you can get to the 120mm fan; you can do this by removing two screws connected to the motherboard tray.
The 5.25 drive bays are also tool-less, located only on this one side of the case, and are used by sliding the tool-less bracket to the front of the case. At first I was concerned it would not hold my drives securely, but I was wrong. They are held in very tightly, and I was unable to push the drives out once they were locked into place.
For the rear exhaust, there is a single 120mm fan. If you look closely, you can see that this fan is rated at 1,000 RPM. It's not a fast fan, but being 120mm it should still push a good amount of air and remain quiet at the same time. All three of the included 120mm fans are identical.
With tool-less expansion slots, there is usually an issue with video cards and the tool-less brackets. I didn't have any issues getting my cards into place. These open simply by pressing in a little brace in the middle of the bracket, then sliding the entire bracket up. Once you have your card in place, you merely push the bracket back down, and it snaps into place, holding your cards in place.
Here you can see the core fan bracket that holds the 120mm fan. This is the first time I've seen this included as part of a case. There are case add-ons you can get that pretty much do the same thing, such as the
Sunbeamtech Wherever PCI Bracket. The default location provides push/pull airflow over the CPU with this fan pushing the air over the CPU, and the rear exhaust pulling the air out. This configuration should help decrease the temperature. If this location will not work for you, you can easily change the position of the fan, or even add a second 120mm fan for extra airflow. Keep in mind though, more fans typically means more noise.
I wanted to point out the expansion brackets. They are a little different than I've seen in the past. Instead of a having to twist them out, they are pre-punched and easily slide out. They are also not like the normal flat brackets, they are a U shape, and snap into the slots. I have to say I really like this style of expansion cover.
